Product Description

25ml, 50ml, 100ml Stainless Steel Hydrothermal Synthesis Autoclave Reactor with Teflon Lined

 

1. Pour the reaction solvent into the PTFE/PPL liner and ensure the freaction solvent is less than 80% of volume.

2. Make sure that the bottom gasket of reactor is in the correct position (protrusion facing down), then place the PTEF/PPL liner and upper gasket, and tighten the kettle lid with a screw.

3. The hydrothermal synthesis reactor is placed in a heater and heated to a desired temperature (less than the specified safe use temperature) according to the specified temperature increase rate.

4. The kettle lid could be opened when you confirm that the temperature in the kettle is lower than the boiling point of the reaction solvent. When the temperature is to be cooled at the end of the reaction, it must be operated strictly in accordance with the specified cooling rate to facilitate safety and the service life of the reactor.

5. After confirming that the temperature in the reactor is lower than the boiling point of the reaction solvent, please loosen the kettle lid with a screw, and then open the kettle lid.

6. The hydrothermal synthesis reactor should be cleaned in time after use to avoid rust. The Sealing part of kettle and kettle lid should be carefully cleaned and protected from damage.

 

Model	KH-25	KH-50	KH-100	KH-150	KH-200	KH-250	KH-300	KH-500	KH-1000
Volume	25ml	50ml	100ml	150ml	200ml	250ml	300ml	500ml	1000ml
Material	SS304 Stainless Steel Kettle; PTFE/PPL Liner
Pressure	≤3Mpa
Temp. Range	PTFE≤240℃ PPL≤300℃ (Highest Temperature)
Heating or Cooling Rate	≤5℃/Min
Remarks	Advancing working temp: 220℃(PTFE), 280℃ (PPL); The highest pressure is 3Mpa.

Payment Terms︰ TT/Paypal/Western Union/Money Gram/LC/DP/DA

Product Image